157
Resolution S84NX S86NX
305 dpi
(1 dot = 0.083 mm
(0.0033"))
108 to 1440 dots 108 to 1440 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
216 to 2880 dots -
• Set the label size to a value that includes the liner.
[Print Mode]
Set the print mode.
The options are as follows:
Continuous
Continuously print the specified number of the media. The media remains in position for printing at
all times.
Dispenser
Peels the liner from the printed label as the label is fed to the media discharge outlet. Once the
printed label has been removed from the product for application, the next label will retract and
position itself for printing.
Linerless
When specialized hardware is installed on the external equipment, then linerless labels are fed
and printed.
Dispense & Print
The printed label advances to the dispensing position while the next data is printed.
If the next data is not available, it is fed to the dispensing position without printing, then backfeed
and regular dispensing are done.
In this mode, when printing is stopped, such as due to a cancel operation during printing of labels,
feed and eject the labels that have been finished printing part way before restarting printing.
Restarting without doing this would cause an error.
• (S84NX only) Do not select Linerless Mode to use RFID tags on an RFID model. If you
set Linerless Mode, you cannot use RFID tags.
[Backfeed]
[Backfeed] is applicable when the print mode is set to dispenser mode, linerless mode or dispense &
print mode.
The options are as follows:
To Next Page
Loading...