SATO S84NX - Media Size for each Print Speed

Media Size for Each Print Speed
558
Media Size for Each Print Speed
The minimum media length varies by the print speed setting.
Continuous
mode
Dispenser mode Dispense & Print
mode
Print
speed
(inches/
sec)
Minimum media
length (with
liner) (mm)
(Thermal transfer)
Minimum media
length (with liner)
(mm)
(Direct thermal)
Minimum media
length (with liner)
(mm)
Minimum media
length (with liner)
(mm)
2 9 13 18 37
3 9 13 18 37
4 9 13 18 37
5 11 13 18 37
6 13 13 18 37
7 15 13 18 37
8 17 13 18 37
9 20 13 18 37
10 23 13 18 37
11 27 13 18 37
12 31 16 18 40
13 35 20 20 44
14 40 25 25 49
15 44 29 29 53
16 50 35 35 59
• If using media smaller than the minimum size, the media will not stop at the right
position, causing a print misalignment.
• Do not send the print data with media size that is smaller than the minimum media
length, even when the sensor is disabled.
• The above minimum media length are valid only if the print position adjustment and
offset adjustment are set to 0 mm. The minimum media length changes when the print
position adjustment and offset adjustment are set to the value other than 0 mm.