SATO S84NX - [Interface] Menu

[Interface] Menu
412
Initial ValueSetting Item
S84NX S86NX
Initialized by
User Reset/
Factory Reset
[Shift Name] - Yes/Yes
[Interface] Menu
Initial values refer to the values set for the product when it was shipped from the factory. If you reset
the product, the values set in the product are initialized. The table below shows the initial value of each
setting item and whether it would be initialized.
• [Network] > [Settings]
• [Network] > [Services] > [Ports]/[NTP]/[LPD]/[FTP]/[SNMP]
• [Network] > [Services] > [Online Services]
• [Network] > [Advanced]
• [RS-232C]/[USB]/[NFC]/[Ignore CR/LF]/[Ignore CAN/DLE]
• [External I/O]
• [RFID]
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
• [Network] > [Settings]
Initial ValueSetting Item
S84NX S86NX
Initialized by
User Reset/
Factory Reset
[LAN]
[IPv4]
[Mode] [DHCP] Yes/Yes
[DHCP] - -
[IP Address] 0.0.0.0 Yes/Yes
[Netmask] 255.255.255.0 Yes/Yes
[Gateway] 0.0.0.0 Yes/Yes
[DNS] 0.0.0.0, 0.0.0.0, 0.0.0.0 Yes/Yes
[IPv6]
[Mode] [Disable] Yes/Yes
[DHCP] - -