425
Setting Item Initial Value Initialized by
User Reset/
Factory
Reset
[Types] [Label] Yes/Yes
[Starting Point] 0 dot Yes/Yes
[RFID Tag Model]
[Load] -Undefined- Yes/Yes
[Edit]
[Antenna Position] [Normal] Yes/Yes
[Write Power] 15 dBm Yes/Yes
[Read Power] 15 dBm Yes/Yes
[Tag Offset] 0 mm Yes/Yes
[Pitch Size]
203 dpi
8 dots
305 dpi
12 dots
609 dpi
24 dots
Yes/Yes
[Save as] RFID_TAG Yes/Yes
[Delete] - -
1
Can also be initialized by [Factory Reset (-Interface)]
2
Can also be initialized by [User Reset (-Interface)]/[Factory Reset (-Interface)]
[Applications] Menu
Initial values refer to the values set for the product when it was shipped from the factory. If you reset
the product, the values set in the product are initialized. The table below shows the initial value of each
setting item and whether it would be initialized.
• [Protocol]/[Auto Switch Group]/[SBPL]
• [SZPL]/[SIPL]
• [SDPL]/[AEP]
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
To Next Page
Loading...