295
After saving is complete, the saved location is displayed.
Press the button to complete.
[Logging Function]
Save the log data.
The setting items are as follows:
[Enabled]
Enable or disable the logging function.
The options are as follows:
Enabled
Enable the logging function. When this function is enabled, the log data is saved when powering
off the product.
Disabled
Disable the logging function.
• The logging function does not operate when powering off is done by using the power
(I/O) switch. Pressing and holding the four arrow ( / / / ) buttons at the
same time for about 3 seconds saves log data and turns off the power.
Saving the log may take a long time. Wait until the product is powered off.
• While the log data is being saved, a message that says "Log Saving" appears on the
screen.
• The product stores log data for the last five times the product was powered off.
• The types of log data that are saved are as follows:
◦ Key events
◦ Analysis status
◦ System logs and settings
◦ Shared memory (including receive buffer)
◦ Operational logs for the barcode scanner
To Next Page
Loading...