355
Adjusting the Dispenser Stop Position
Set the [Offset] in the [Printing] > [Advanced] > [Adjustments] menu to adjust the dispenser stop
position.
• The above dispenser stop position indicates the stop position when the media sensor
type is set to Gap.
• You can adjust the dispenser stop position during printing by registering the
[Adjustments] menu to the [Shortcut] menu in advance.
1.
When the product is in Online mode, press the button on the operator panel to
change to Offline mode.
2.
Press the button to show the [Settings] menu.
To Next Page
Loading...