SATO S84NX - [FPGA Version]; [Counters]

[Counters]
300
Main
Shows the Main firmware version.
[FPGA Version]
Shows the FPGA version on the product.
The item is as follows:
Name
Shows the FPGA version.
[Counters]
Shows information about the counters on the product.
• Only SATO authorized service personnel are permitted to clear the counter.
The setting items are as follows:
[Head]
Shows information about the head counter on the product.
Life
Shows the current print distance.
Head 1
Head 2
Head 3
The current print distance is shown in [Head 1]. When you replace the print head and the counter
is cleared, the value of [Head 2] appears in [Head 3] and the value of [Head 1] appears in [Head
2]. [Head 1] will start to count from 0 again.
[Dispenser]
Shows the current print distance in dispenser mode.
[Belt(Gear Box)]
Shows the current distance the gearbox timing belt has advanced the media in the eject direction.
Belt 1
Belt 2