[Support Info]
294
Disabled
Disable the clone notification.
The message appears after you change settings, when you go from the setting menu to the Offline
screen.
Press the button to move to the [Clone] settings screen.
• To use this function, connect the USB memory to the connector on the back of the
product. If it is connected to the connector on the side of the product, this function does
not work.
• When this function is enabled, the USB connector (Type A) on the back is dedicated to
the clone function, and functions other than the clone function cannot be used.
[Support Info]
Save various information about the product, such as attached options, serial number, application
versions and settings configuration, in a text file (.txt) to the USB memory.
Available only if you have installed the USB memory.
• Be sure to perform a virus check on the USB memory before connecting it to the
product. SATO Corporation shall not be held responsible for any product malfunctions
caused by a virus spread via USB memory.
By selecting [Support Info] and pressing the button, the support information is saved to the
USB memory.
To Next Page
Loading...