SATO S84NX - List of Initial Values; [Printing] Menu

407
List of Initial Values
[Printing] Menu
Initial values refer to the values set for the product when it was shipped from the factory. If you reset
the product, the values set in the product are initialized. The table below shows the initial value of each
setting item and whether it would be initialized.
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
Initial ValueSetting Item
S84NX S86NX
Initialized by
User Reset/
Factory Reset
[Label Length]
203 dpi
20000 dots
305 dpi
18000 dots
609 dpi
9600 dots
203 dpi
20000 dots
305 dpi
18000 dots
Yes/Yes
[Label Width]
203 dpi
832 dots
305 dpi
1248 dots
609 dpi
2496 dots
203 dpi
1340 dots
305 dpi
2010 dots
Yes/Yes
[Auto Measure] [Disabled] Yes/Yes
[Printing Mode] [Use Ribbon] Yes/Yes
[Ribbon Near End] [Enabled] Yes/Yes
[Speed]
203 dpi
6 ips
305 dpi
6 ips
609 dpi
3 ips
203 dpi
6 ips
305 dpi
6 ips
Yes/Yes
[Sensor Type] [Gap] Yes/Yes