SATO S84NX - Page 408

[Printing] Menu
408
Initial ValueSetting Item
S84NX S86NX
Initialized by
User Reset/
Factory Reset
[None] (When [Print Mode] is
[Linerless])
[Micro Label Print Mode]
[Micro Label Print Mode] [Disabled] Yes/Yes
[Auto Label Length Detection] [Enabled] Yes/Yes
[Label Length Averaging Count] 3 Yes/Yes
[Label Length]
203 dpi
320 dots
305 dpi
480 dots
609 dpi
960 dots
203 dpi
320 dots
305 dpi
480 dots
Yes/Yes
[Print Mode] [Dispenser] Yes/Yes
[Backfeed] Before (If [Print Mode] is set to
[Dispenser], [Dispense & Print] or
[Linerless])
None (If [Print Mode] is set to
[Continuous])
Yes/Yes
[Darkness] 6 Yes/Yes
[Imaging]
[Vertical] 0 dot Yes/Yes
[Horizontal] 0 dot Yes/Yes
[Advanced]
[Calibrate]
[Auto-calibration] [Gap + I-Mark] -
[GAP Levels] Value adjusted by the factory No/No
[GAP Slice Level] Auto No/No
[I-Mark Levels] Value adjusted by the factory No/No
[I-Mark Slice Level] Auto No/No
[Head Check] [Off] Yes/Yes