SATO S84NX - Page 409

409
Initial ValueSetting Item
S84NX S86NX
Initialized by
User Reset/
Factory Reset
[Head Check Mode] [Always] Yes/Yes
[Every Page] 1 Yes/Yes
[Check Media Size] [Disabled] Yes/Yes
[Adjustments]
[Offset] 0 dot No/No
[Pitch] 0 dot No/No
[Pitch Offset] 0 dot No/No
[Darkness Adjust] 50 No/No
[Start Online] [Enabled] Yes/Yes
[Feed After Error] [Disabled] Yes/Yes
[Feed At Power On] [Disabled] Yes/Yes
[Finisher Feed] 0 dot ([Standard]) Yes/Yes
[Feed Speed]
[Sync with Print Speed] [Enabled] Yes/Yes
[Feed Speed] 6 ips Yes/Yes
[Backfeed Speed] 6 ips Yes/Yes
[Paper End] - Yes/Yes
[Sensor Type] [Using I-mark] Yes/Yes
[Paper End Distance]
203 dpi
120 dots
305 dpi
180 dots
609 dpi
360 dots
Yes/Yes
[Head Base Position] [Standard] Yes/Yes
[Prioritize] [Commands] Yes/Yes
[Reprint] [Disabled] Yes/Yes
[Print End Position] 0 dot Yes/Yes