279
Resolution S84NX S86NX
(1 dot = 0.083 mm
(0.0033"))
609 dpi
(1 dot = 0.042 mm
(0.0017"))
-90 to 0 to 90 dots -
When you decrease the setting value, the stop position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the stop position moves opposite the feed direction (toward
the end part of the media).
Darkness Adjust
Fine tune the print darkness of the head check print.
The setting range is from 0 to 99.
0 is the lightest and 99 is the darkest.
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• The changes to the settings in this menu are linked and are changed with each of the
test print settings under the [Test Print] menu.
• The settings in [Pitch], [Offset], and [Darkness Adjust] are linked and are changed with
the settings in the [Printing] > [Advanced] > [Adjustments] menu.
[HEX-Dump]
Save the hex dump print data or dump data from the receive buffer to the USB memory.
The setting items are as follows:
[Hex Dump Mode]
Enable or disable the Hex Dump mode.
If you set [Hex Dump Mode] to [Enabled], the product prints the received data and at the same time
creates a file of the received data inside "hexdump/".
When you return the setting to [Disabled], you can check the file on the screen.
To Next Page
Loading...