367
Pressure Balance Setting
Required tool
• Slotted screwdriver
The adjustment procedure for the pressure balance is as follows:
1. Open the top cover of the product.
2. Turn the head lock lever (1) clockwise to unlock the print head.
3. To expose the adjustment dial (2) beside the head lock lever as shown, turn the
head lock lever (1) back until before it locks.
The numeral (3) at the bottom (looking parallel with print head) of the adjustment dial indicates the
current value set for pressure balance.
4. Use the slotted screw driver to turn the adjustment dial (2), and then set the
pressure balance according to the media width and media thickness.
To Next Page
Loading...