SATO S84NX - Page 421

421
Initial ValueSetting Item
S84NX S86NX
Initialized
by User
Reset/
Factory
Reset
[Ignore CAN/DLE] [Disabled] Yes/Yes
• [External I/O]
Initial ValueSetting Item
S84NX S86NX
Initialized
by User
Reset/
Factory
Reset
[External I/O]
[Print Start Signal]
[Enable] [Enabled] Yes/Yes
[PIN] [PIN20] Yes/Yes
[Signal State] [Active Low] Yes/Yes
[EXT I/O Re-print]
[Enable] [Disabled] Yes/Yes
[PIN] [PIN8] Yes/Yes
[Signal State] [Active Low] Yes/Yes
[Continuous Print] [Disabled] Yes/Yes
[Enhanced Reprint] [Disabled] Yes/Yes
[Signals]
[Inputs]
[PIN7]
[Function] [Label Near End] Yes/Yes
[Signal State] [Active Low] Yes/Yes
[PIN9]
[Function] [Dispense In] Yes/Yes
[Signal State] [Falling Edge] Yes/Yes
[PIN10]