SATO S84NX - Page 420

[Interface] Menu
420
Initial ValueSetting Item
S84NX S86NX
Initialized by
User Reset/
Factory Reset
[UDP Source Port]
[Existing Port No.] 53 -
[Additional Port No.] - Yes/Yes
[UDP Destination Port]
[Existing Port No.] 161 19541 -
[Additional Port No.] - Yes/Yes
[ICMP Type]
[Existing ICMP Type] 0 8 -
[Additional ICMP Type] - Yes/Yes
• [RS-232C]/[USB]/[NFC]/[Ignore CR/LF]/[Ignore CAN/DLE]
Initial ValueSetting Item
S84NX S86NX
Initialized
by User
Reset/
Factory
Reset
[RS-232C]
[Baudrate] [115200] Yes/Yes
[Parameters] [8-N-1] Yes/Yes
[Flow Control] [STATUS4] Yes/Yes
[BCC] [Disabled] Yes/Yes
[USB]
[Flow Control] [Status4] Yes/Yes
[BCC] [Disabled] Yes/Yes
[Change USB Serial] [Disabled] No/Yes
[NFC]
[I/F Enable] [Enabled] Yes/Yes
[Ignore CR/LF] [Disabled] Yes/Yes