SATO S84NX - Page 156

[Micro Label Print Mode]
156
• (S84NX only) When using RFID models, Micro Label Print Mode cannot be used.
The setting items are as follows:
[Micro Label Print Mode]
Enable or disable the use of Micro Label Print Mode.
The options are as follows:
Enabled
Enable Micro Label Print Mode.
Disabled
Disable Micro Label Print Mode.
[Auto Label Length Detection]
Enable or disable automatic measurement of label length when the [Micro Label Print Mode] is set to
[Enabled].
The options are as follows:
Enabled
Enable the auto label length detection.
Disabled
Disable the auto label length detection.
• If the print start position is out of alignment when using automatic measurement of
label length, use [Label Length] to set the label length manually.
[Label Length Averaging Count]
Set the number of labels measured to be used for averaging the automatically set label length when
the [Micro Label Print Mode] is set to [Enabled] and the [Auto Label Length Detection] is set to
[Enabled].
The setting range is from 1 to 10.
[Label Length]
Set the label length manually when the [Micro Label Print Mode] is set to [Enabled] and the [Auto
Label Length Detection] is set to [Disabled].
The setting range varies depending on the print resolution of the product.
The setting range of the label length is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
72 to 960 dots 72 to 960 dots