289
Setting
Include barcodes that are not created by barcode commands (such as graphic data or preprinted
barcodes) as the target of the barcode readability check.
You need to specify the number of barcodes per label in [Barcodes per Label].
[Barcodes per Label]
Specify the number of barcodes per label when you include barcodes which are not created by
barcode commands as the target of the barcode readability check.
Appears only if you have selected [Readable] in the [Mode] menu. Available only if you have selected
[Setting] in the [Set No. of Barcodes] menu.
The setting range is from 1 to 10.
• When excluding first barcode(s) from the check target by setting [Start Position],
specify the number of barcodes without the excluded barcodes.
[Start Position]
Adjust the position at which the barcode check starts (position of the barcode checker at which reading
starts).
The barcode checker starts reading each media after the specified length passes from the printing
start position.
This setting can be used to exclude first barcode(s) from the check target when multiple barcodes are
printed on each media.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
10 to 20000 dots 10 to 20000 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
15 to 18000 dots 15 to 18000 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
30 to 9600 dots -
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[VOID Print]
Set whether to print error marks on the media when a barcode reading error or barcode comparison
error occurs.
To Next Page
Loading...