[External I/O]
226
Appears only if you have selected [Enabled] in the [Enable] menu.
The options are as follows:
Enabled
Enable the enhanced reprint function.
Disabled
Disable the enhanced reprint function.
[Signals]
Assign to the input/output signals to the pin number.
• Do not assign the same function to multiple pin numbers when you are assigning input
signal and output signal functions to pin numbers.
The setting items are as follows:
[Inputs]
Assign the input signals to the pin number.
Select the pin to assign the signal.
The available pins are as follows:
[PIN7]/[PIN9]/[PIN10]/[PIN21]/[PIN22]/[PIN23]
The setting items are as follows:
[Function]
Select the function to assign.
The options are as follows:
Label Near End
The product becomes label near end status when a signal is detected.
Feed
Media feeds when a signal is detected.
Cancel
Cancels print data when a signal is detected.
Online/Offline
Switches Online/Offline modes when a signal is detected.
Dispense In
When [Backfeed] in the [Printing] menu is set to [Controled], backfeed is performed when a signal
is detected.
Unassigned
No signal is assigned.
To Next Page
Loading...