SATO S84NX - Page 225

225
[Enable]
Set the reprint function that uses the external terminal.
Appears only if [Print Start Signal] > [Enable] is enabled.
The options are as follows:
Enabled
Enable the reprint function.
Disabled
Disable the reprint function.
[PIN]
Assign the pin number for the Reprint signal input.
Appears only if you have selected [Enabled] in the [Enable] menu.
The options are as follows:
PIN8
Assign Pin 8 to the Reprint signal.
PIN20
Assign Pin 20 to the Reprint signal.
[Signal State]
Select the signal state to assign.
The options are as follows:
• [Falling Edge]
• [Rising Edge]
• [Active Low]
• [Active High]
[Continuous Print]
When this is enabled, reprint can be executed via the Print Start signal (PRIN).
Reprint can be executed either by enabling this setting or by the PIN assigned to the Reprint signal.
Appears only if you have selected [Enabled] in the [Enable] menu.
The options are as follows:
Enabled
Enable the continuous print function.
Disabled
Disable the continuous print function.
[Enhanced Reprint]
When this is enabled, the data that was just printed is reprinted even when the print data remains.