SATO S84NX - Page 224

[External I/O]
224
[Print Start Signal]
Printing starts if the Print Start signal (PRIN) is detected when the print data is available in Online
mode.
The setting items are as follows:
[Enable]
Enable or disable the Print Start signal (PRIN).
If you have selected [Dispenser], [Linerless], or [Dispense & Print] in the [Printing] > [Print Mode]
menu, the setting is fixed as [Enabled].
The options are as follows:
Enabled
Enable the Print Start signal (PRIN).
Disabled
Disable the Print Start signal (PRIN).
[PIN]
Assign the pin number for the Print Start signal (PRIN) input.
Appears only if you have selected [Enabled] in the [Enable] menu.
The options are as follows:
PIN8
Assign Pin 8 to the Print Start signal (PRIN).
PIN20
Assign Pin 20 to the Print Start signal (PRIN).
AEP
Print starts when a request is sent from the AEP application.
[Signal State]
Select the signal state to assign.
Appears only if you have selected an item other than [AEP] in [PIN].
The options are as follows:
• [Falling Edge]
• [Rising Edge]
• [Active Low]
• [Active High]
[EXT I/O Re-print]
Prints the previously printed content again if the Reprint signal is detected when the print data is not
available in Online mode.
The setting items are as follows: