229
The setting items are as follows:
[Antenna Position]
Follow the Inlay Configuration Guide to select an RFID antenna to use. For details, access the
following URL:
https://www.sato-global.com/rfid/guide.html
To use inlays that are not in the Inlay Configuration Guide, contact your SATO sales representative or
reseller.
The options are as follows:
Normal
Use a standard antenna (adjustable).
Front
Use a short pitch antenna (fixed position).
[Write Power]
Set radio power level used to write information to inlay according to the Inlay Configuration Guide. For
details, access the following URL:
https://www.sato-global.com/rfid/guide.html
To use inlays that are not in the Inlay Configuration Guide, contact your SATO sales representative or
reseller.
The setting range is from 0 to 30 dBm.
The setting range differs depending on where the product is being operated.
[Read Power]
Set radio power level used to read information from inlay according to the Inlay Configuration Guide.
For details, access the following URL:
https://www.sato-global.com/rfid/guide.html
To use inlays that are not in the Inlay Configuration Guide, contact your SATO sales representative or
reseller.
The setting range is from 0 to 30 dBm.
The setting range differs depending on where the product is being operated.
[Tag Offset]
Set the position at which to start writing data to the inlay. Data is written to an inlay on each tag at the
point where the inlay passes over the product's RFID antenna, which is at the distance, from the print
start position, specified in this setting.
This setting will be used when inlays are not compatible with the product's antenna positions. For
details, access the following URL:
https://www.sato-global.com/rfid/guide.html
To use inlays that are not in the Inlay Configuration Guide, contact your SATO sales representative or
reseller.
The setting range is from -15 to 240 mm (-0.59 to 9.45").
To Next Page
Loading...