SATO S84NX - Page 230

[RFID] (S84NX Only)
230
The minimum value is 0 mm (0") if other than [Continuous] is selected in the [Printing] > [Print Mode]
menu.
[Reader Model]
Shows the RFID module model.
[Reader Version]
Shows the RFID module firmware version.
[View]
Shows the inlay data.
Press the button to change to the [Memory Bank] screen.
Press the button (READ) to change to the [Data Reading] screen, to read and show the data.
On the [Data Reading] screen, you can press the button to feed the media and attempt to
read the tag currently set in the product.
When no inlay has been detected, "Tag not found" appears on the screen. When multiple inlays have
been detected at the same time, "Multiple tags error" appears on the screen.
[Memory Bank]
Set the memory area of the inlay to read.
The readable memory areas are as follows:
EPC
EPC area
TID
TID area
USER
USER area
PC
PC/AFI area
RSSI
RSSI area
[Filter Function]
Set the filter function by RSSI (Received Signal Strength Indication). If the RSSI value read while
printing an RFID tag is lower than the specified threshold value, an RFID tag error occurs. An error
message is printed on the inlay/RFID tag that caused the error.
The setting items are as follows:
[RSSI Filter]
Enable or disable the RSSI filter function.
The options are as follows: