[Barcode Checker]
292
Format ID Description
SRSR Size of read data (bytes)
drdr... Read data
Check result
SUCCESS
• In readable mode, this means everything is correct.
• In comparison mode, this means that the read data and
print data match.
FAILURE
• In readable mode, this means that the barcode checker
could not read the number of printed barcode data.
• In comparison mode, this means that the read data and
print data do not match.
RRRRRRR
IGNORED This means that the data is read during a period other
than from the start to the end of checking, while the
product is active.
IC The amount of print data as a check target
*If the check result is "IGNORED", this becomes "--".
SCSC Size of print data (bytes)
*If the check result is "IGNORED", this becomes "----".
dcdc... Print data
*If the check result is "IGNORED", nothing is output.
The setting items are as follows:
[Copy]
Copy the barcode check log data to the USB memory.
Available only if there is barcode check log data in the product and if you have installed the USB
memory.
• Be sure to perform a virus check on the USB memory before connecting it to the
product. SATO Corporation shall not be held responsible for any product malfunctions
caused by a virus spread via USB memory.
Press the button to copy the log data to the USB memory.
[Remove]
Delete the barcode check log file.
Available only if there is barcode check log data in the product.
Press the button to delete the log data.
To Next Page
Loading...