291
[Host Notification]
Set whether to return the barcode check results to the host from which the print data is sent.
The options are as follows:
Enabled
Return the barcode check result of each label to the host as follows:
◦ When the check is successful: <STX>BV, OK<ETX>
◦ When the check is unsuccessful: <STX>BV, NG<ETX>
Disabled
Do not return the barcode check results to the host.
[Logs]
Manage the barcode check log data saved in the product.
Available only if there is barcode check log data in the product.
Note that new log data overwrites on older log data when the log file reaches its maximum size (1
MB).
Format and Contents of the Barcode Check Log Data
The barcode check log data is created in the following format:
Format ID Description
YYYY Year of the date when the barcode check was performed
MM Month of the date when the barcode check was performed
DD Day of the date when the barcode check was performed
hh Hour of the time when the barcode check was performed
mm Minute of the time when the barcode check was performed
ss Second of the time when the barcode check was performed
ZZZ Time zone
TTTTTTT The total number of printed labels after the product is powered on.
*When the total number of printed labels becomes greater than an 8-digit
number, the output digit will increase.
IR The number of read data received after reaching the position at which the
check starts.
*When the check result is "IGNORED", this shows "00".
To Next Page
Loading...