SATO S84NX - Page 263

263
[Change Printhead]
Enable or disable the notification function about when the print head needs to be replaced.
The options are as follows:
Enabled
Enable the notification function.
Disabled
Disable the notification function.
[Printhead Interval]
Set the notification interval about when the print head needs to be replaced.
You can change this setting if you have selected [Enabled] in the [Change Printhead] menu.
The product shows the print distance as a set value. The setting range is from 10 to 100 km.
[Printhead Count]
Shows the current print distance.
[Change Platen]
Notify when the platen roller needs to be replaced.
The setting items are as follows:
[Change Platen]
Enable or disable the notification function about when the platen roller needs to be replaced.
The options are as follows:
Enabled
Enable the notification function.
Disabled
Disable the notification function.
[Platen Interval]
Set the notification interval about when the platen roller needs to be replaced.
You can change this setting if you have selected [Enabled] in the [Change Platen] menu.
The product shows the fed distance as a set value. The setting range is from 10 to 100 km.
[Platen Count]
Shows the current distance the platen roller has fed.
[Change Belt(Gear Box)]
Notify when the gearbox timing belt needs to be replaced.
The setting items are as follows: