[Network]
216
[Allow
Services
And Ports]
[TCP Source
Port]
[TCP
Destination
Port]
[UDP
Source
Port]
[UDP
Destination
Port]
[ICMP Type]
[WebConfig] - 80,443 - - -
*The values may vary depending on other settings.
[Custom Settings]
Specify the ICMP type or the port number of TCP or UDP to allow communication.
Available only if you have selected [Enabled] in the [Enable] menu.
The setting items are as follows:
[TCP Source Port]
Register the TCP source port number to allow communication.
[Existing Port No.]
The port number of the items enabled in [Allow Services And Ports] are shown.
[Additional Port No.]
Register the TCP source port number to allow communication.
The acceptable input values are as follows:
Active port number An integer from 1 to 65535
Specifying multiple values Delimit active port numbers using a comma “,”
Specifying a range Create a range of active port numbers using a colon “:” (Input in the
order of low port number: high port number)
Maximum number of
specifications
21 ports in total by specifying with either numbers or a range
No setting Blank
Input Example
Port number Comments
10000 -
10000,10001,10002,10003
10000:10003
This results in the same ports in both settings to
be allowed.
10000,10001,10002,10003,20000
10000:10003,20000
This results in the same ports in both settings to
be allowed.
To Next Page
Loading...