245
The options are as follows:
Enabled
Change the Kanji commands ESC+K5, ESC+K6 and ESC+K7 in the received data to the proper
commands and print.
◦ ESC+K5: 16x16 dots Kanji in horizontal line with one-byte character
◦ ESC+K6: 24x24 dots Kanji in horizontal line with one-byte character
◦ ESC+K7: 22x22 dots Kanji in horizontal line
Disabled
Do not change the Kanji commands ESC+K5, ESC+K6 and ESC+K7 in the received data. The
product behavior when it receives these commands is as follows:
◦ ESC+K5: Print with 40x40 dots Kanji in horizontal line.
◦ ESC+K6: A command error occurs and the data will not be printed.
◦ ESC+K7: A command error occurs and the data will not be printed.
[Call Font/Logo]
Set how to process the character code specified in Recall font & logo command (ESC+RF).
The options are as follows:
Enabled
Character codes are processed in little-endian format.
Disabled
Character codes are processed in big-endian format.
[A3 Command Save(S-type)]
Set whether to save all values (with or without +/- sign) specified by the Base Reference Point
command ESC+A3 to the product's [Imaging] menu.
The options are as follows:
Enabled
All values (with or without +/- sign) specified by the command ESC+A3 are saved to the product's
[Imaging] menu.
Disabled
Only values without +/- sign specified with the command ESC+A3 are saved to the product's
[Imaging] menu. Values with +/- sign are not saved.
[PDF417 ECC Level fixed]
Set whether to print the PDF417 code with the security level specified by the PDF417 printing
command.
The options are as follows:
To Next Page
Loading...