SATO S84NX - Page 277

277
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• The changes to the settings in this menu are linked and are changed with each of the
test print settings under the [Test Print] menu.
• The settings in [Pitch], [Offset], and [Darkness Adjust] are linked and are changed with
the settings in the [Printing] > [Advanced] > [Adjustments] menu.
[Head Check]
Perform the head check print.
1. Check and set the items as listed on the [Head Check] menu.
2.
Press the button to start the head check print. Press the button again to pause
the print.
To stop the head check print, first pause the print and then press the button.
The setting items are as follows:
Label Width
Set the media width used for the head check print.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
320 to 832 dots 320 to 1340 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
480 to 1248 dots 480 to 2010 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
960 to 2496 dots -
Label Length
Set the length of one piece of the media used for the head check print.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi 40 to 240 dots 40 to 240 dots