Operations in Dispense & Print Mode
336
Timing Chart (Without Head Check)
• If print data contains the RFID command, then printing stops temporarily after printing
1 label. In this case, the external signal input operations are the same as when head
check is enabled.
• If you have selected [Enabled] in the [Printing] > [Advanced] > [Calendar Setting Mode]
> [Calendar Reprint] menu or the [Interface] > [External I/O] > [EXT I/O Re-print] >
[Enhanced Reprint] menu, then it is the operation of dispenser mode.
Timing Chart (With Head Check)
• It is recommended to use TYPE3 or TYPE4 PREND (Print End) signal.
• If you have selected [Enabled] in the [Interface] > [External I/O] > [EXT I/O Re-print] >
[Enhanced Reprint] menu, then it is the operation of dispenser mode.
*1 Keep the PRIN (Print Start) signal until the PREND (Print End) signal is outputted.
*2 If you have selected [Enabled] for [Printing] > [Advanced] > [Printing Operations] > [Throughput
Mode], then it is 7.5 ms.
To Next Page
Loading...