SATO S84NX - Page 349

349
RFID Write with Dispense & Print Mode (S84NX Only)
When the dispense & print mode is selected, RFID encoding is performed before printing while
stopping at the print head position.
RFID tag offset cannot be used in the dispense & print mode. The setting value will be ignored even if
tag offset is set. Also, this mode cannot be used for mixed issuance of RFID items and items that do
not contain RFID commands.
Also, the RFID tag error print in the dispense & print mode is the same as the error print in the
continuous or dispenser mode.
*1 If the next data is received after printing finishes, then the next print operation is done and
dispensing stops at the dispensing position.
*2 If the next data is not completed before printing is finished, then blank media is fed and dispensing
stops at the dispensing position.
*3 The EPC code write <IP0> command writes the data at this inlay position. The RFID read [DC2]PJ,
printing tag data <TU>, and EPC/TID return <RU> commands acquire the information at this inlay
position.