SATO S84NX - Page 452

Replacing the Print Head
452
• (S84NX only) For RFID models, the UHF RFID antenna is installed on the print head.
Be careful not to overly pull the antenna cable when replacing the print head. Contact
your SATO reseller, dealer, or technical support for more information.
8. Connect all the connectors (6) to the new print head.
• Handle the print head with care. Do not contaminate or scratch the sensitive print head
surface.
9. Pull back and arrange the cables (7) from the top of the print head assembly.
10. Install the print head (5) to the print head assembly.
Align the print head and press the print head upward until it is latched.
11.
Attach the cover (3) back to the top of the print head assembly , and tighten the
thumbscrew (2) .