REVISION RECORD
REVISION RECORD 214
8. REVISION RECORD
modify:
1. Modification of factory values and setting ranges of some parameters
2. Add Appendix 5: Compatibility Description of European Standards
modify:
1. Modify the communication line specifications in 7.4.4
2. Modify the cooling method of individual models in 3.1 electrical specifications
add:
1. Add 3.7.3 grounding torque table
modify:
Modify the parameter P.31, the second option, when P.72>"5", change to when P.72
>"9"
add:
Added 7.4.4 DU10 operator
increase:
1. Add the description of P.XXX in 1.3
modify:
1. Modify the description of V indicator in 4.1(d)
2. Modify 3.1 Inverter weight
modify:
1. Fix some errors
modify:
1. Modification of factory values and setting ranges of some parameters
2.3.6.3 Delete A frame model
add:
1. Add 5.7.7 to earth leakage current protection
2. Add 5.11.3 current filtering
3. Add 5.1.7 PWM carrier frequency rated current and carrier frequency curve diagram
modify:
3.7 Terminal wiring diagram
modify:
7.5 Appendix 5: Compatibility Description of European Standards
2.1 Nameplate description
modify:
3.5.3 Installation instructions: ambient temperature matters needing attention when
installing multiple units
modify:
3.6.3 Regenerative braking resistor
modify:
3.7 Terminal wiring, delete output signal
add:
7.6 Appendix 6: WEEE Mark
modify:
3.6.3 Delete A frame model
add:
1. Add 5.1.4 When the inverter starts, it will automatically enter the monitoring mode to
display the current constant pressure system target pressure and feedback pressure
2. Add 5.7.8 Input phase loss protection option
add:
1.5.2.13 Remote control frequency acceleration and deceleration time selection
2. 5.9.4 PID current feedback disconnection detection
3.5.10.11 Voltage stall action level
modify:
Improve some parameter descriptions
add:
5.7.11 Fire mode
modify :
Improve and optimize the description of some parameters