134
99
Connections and Communications with External EquipmentConnections and Communications with External Equipment
Key Operations
Command Function Description
POWER [POWER]
Press [ POWER] key
DIGIT [1d/10d]
Press [ 1d/10d] key
PRINT [PRINT]
Press [ PRINT] key
TARE [0/T]
Press [ 0/T] key, Taring zero display
CAL [CAL]
Press [ CAL] key, Calibration CAL execution
MENU [MENU]
Press [ MENU] key
ION [ION]
Press [ ION] key
ENTER [OK]
Press [ OK] key
UP
[ UNIT] Press [ UP] key
DOWN
[ FUNC] Press [ DOWN] key
LEFT
[ LEFT] Press [ LEFT] key
RIGHT
[ RIGHT] Press [ RIGHT] key
Mode Setup
Command Function Description
Application Standard measurement Mode (Overall)
R Cancel Application Standard
measurement Mode settings
Piece counting measurement
PCS ? Unit (PCS) mode setting ?: Numerals 1 – 5 (number specification for destination sample)
UW?=XX.XXXX Unit weight setting ?: Numerals 1 – 5, XX.XXXX: Set value (g)
UW? Unit weight loading ?: Numerals 1 – 5
UB?=XXXXX Standard unit setting ?: Numerals 1 – 5, XXXXX: Set value (1 - 10000)
UB? Standard unit loading ?: Numerals 1 – 5
RECALC Unit weight re-calculation The unit weight is recalculated using the result of the weight value (UNIT
count) calculated with the weight value (g) at that point.
Percent measurement
G
% g switch units
%? % mode setting ?: Numerals 1 – 3 (number specification for destination sample) or none. In
the event of none, it will move to the Percent measurement mode recently
moved to, and the load currently on the pan will be recorded as 100%.
Formulation
M Formulation mode Setting
Add-on
+ Add-on mode setting
Solid specific gravity
SD Solid specific gravity mode
setting
Liquid Density
LD Liquid density mode setting