Shimadzu AP W-AD Series - Page 136

136
99
Connections and Communications with External EquipmentConnections and Communications with External Equipment
 Miscellaneous
Command Function Description
TYPE Model TYPE_AP224W
VER Version VER_X.XX.XX
5-digit numeral 1.00.11
SN Serial Number SN_XXXXXXXXXX
Serial No. 10 digits, Maximum 12 digits
ex D447400101
MAX Maximum weighing capacity MAX_XXX
X: Maximum weighing capacity
MIN Minimum display value MIN_X.XXXXX
X: Minimum display value
{ ??... { ??... ??...Echo-back
??: alphanumeral string (maximum 32 characters)
“_ (Space) “ Clears the receiving buffer
stored within the balance
 W-AD Series automatic door operation
Some of the commands which can be used on the AP W-AD Series are shown in the table below.
There are also other commands in addition to these commands which function in a manner equivalent
or similar to products from other companies. Refer to the Shimadzu Corporation website for details.
Command Function Remarks
RO=LLLRRRUUU Opening position settings for
each door
Settings for the door opening positions (positions to which the
doors will be opened).
The opening positions can be set to 0 or between 20 to 100 (%) for
LLL: left door, RRR: right door, and UUU: top door. If set to 1 to 19
(%), the setting will change to 20 (%).
Setting the opening positions using this command will overwrite
the opening positions for each door set using the door open and
close key (right).
Example: “RO=050050050” will set the left, right, and top door to
each open to the half-way position (50% open).
OA Open the top, right, and left (all
3) doors
Opens all 3 doors. Each door will stop at the opening positions
configured in the opening position settings for each door.
WS 0 Close the top, right, and left (all
3) doors
Closes all 3 doors.
WS 1 Open the right door Opens only the right door (the door to the right when facing the
display). Will stop at the opening position set using the door open
and close key (right).
CR Close the right door Closes only the right door (the door to the right when facing the
display). This command will close only the right door even after
doors are opened using the open all 3 doors command.
WS 2 Open the left door Opens only the left door (the door to the left when facing the
display). Each door will stop at the opening positions configured in
the opening position settings for each door.
CL Close the left door Closes only the left door (the door to the left when facing the
display). This command will close only the left door even after
doors are opened using the open all 3 doors command.
OU Open the top door Opens only the top door (the door on top when facing the display).
Each door will stop at the opening positions configured in the
opening position settings for each door.
CU Close the top door Closes only the top door (the door on the top when facing the
display). This command will close only the top door even after
doors are opened using the open all 3 doors command.
DOORR Door open and close key (right) Corresponds to the door open and close key (right) short press
operation.
DOORL Door open and close key (left) Corresponds to the door open and close key (left) short press
operation.