SICK DL100

Operating instructions Distance measuring device DL100 – CANopen®
Operation via Ethernet (Ethernet interface)
70 © SICK AG • Subject to change without notice • 8015416/ZPN2/2017-09-08
Field "Frequency" Requirements for the display
• Devices with the option "Frequency" (DL100-xxxBxxxx)
Parameter Description
Frequency set Select frequency range.
Read/Write access
• Read and write
Input value
• 0: Mode 1 / 1: Mode 2 / 2: Mode 3 / 3: Mode 4
Unit
• °C
Factory setting
• –10
Table 44: Page "Parameter settings" – eld "Frequency"
Field "Store parameter"
Parameter Description
Storage
Parameterchangesonlyenterintopermanenteectif
they are saved via the button "Storage".
Read/Write access
• Write only
Table 45: Page "Parameter settings" – eld "Store parameter"
Field "Set parameters to
default values"
Parameter Description
Parameter
Reset
Click the button "Parameter Reset" to reset the parameters to
factory settings.
Read/Write access
• Write only
Table 46: Page "Parameter settings" – eld "Set parameters to default values"