SICK EtherCAT microScan3

7.7 Identification
Overview
Figure 62: Identification
1
Parameters for the project and the device
In the Ident
ification dialog box, you can optionally enter names and information to
uniquely identify the application, project, and devices.
Device name
If a number of safety laser scanners are used in an application or in a project, a unique
device name helps to tell the individual devices apart.
►
Give each device a unique device name.
Project name
T
he project name is used to identify an entire project. The same project name should
be chosen for all devices in the project.
►
Enter a project name.
Application name
T
he application name can be the same for a number of devices in the project. It
highlights that these devices realize an application together, by responding to one
another for example.
►
Enter an application name.
CONFIGURATION 7
8025220/1L9Q/2023-08-14 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherCAT®
95
Subject to change without notice