Siemens HydroRanger 200 HMI - Page 247

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
245
Flowrate decimal (2.13.4.6.)
Sets the maximum number of decimal places to be displayed in the auxiliary reading.
Index
Single-point model
Dual-point model
Global
Transducer
Options
No digits
1 digit
*2 digits
3 digits
Altered by
Decimal position (2.12.4.) (Page 237)
The maximum number of decimal places shown in the Primary Reading is controlled by
Decimal Position (2.12.4.) (Page 237).
Flowrate units (2.13.4.7.)
Defines the units used for flow calculations.
Note
Set this parameter only when using BS
-3680/ISO 4359 Rectangular Flume or BS-3680/ISO
1438/1 Thin Plate V
-Notch Weir [Primary Measuring Device (2.13.2.) (Page 240) =
Rectangular Flume BS
-36806 or Thin Plate V-Notch Weir BS-36807]. Use the default option
of
Ratiometric calculation for Flowrate Units (2.13.4.7.) when Primary Measuring Device
(2.13.2.)
(Page 240) = Exponential devices, Palmer-Bowlus Flume, H-Flume, Universal
Linear Flow Calculation, or Universal Curved Flow Calculation.
Index
Single-point model
Dual-point model
Global
Transducer
Options
Ratiometric
[Primary Measuring Device (2.13.2.)
(Page 240) = all]
*Ratiometric calculation
Absolute
[Primary Measuring Device (2.13.2.)
(Page 240) = Rectangular Flume BS-
3680 or Thin Plate VNotch Weir BS-
3680 only]
L/S (Liters/second)
M
3
/H (Cubic meters/hour)
M
3
/D (Cubic meters/day)
FT
3
/S (Cubic feet/second)
IMPGAL/MIN (Gallons/minute – Imperi-
al)
MIMPGAL/D (Million gallons/day –
Imperial)
GAL/MIN (Gallons/minute – U.S.)
MUSGAL/D (Million gallons/day – U.S.)
Alters
Flow time units (2.13.4.4.) (Page 244)
Altered by
Primary measuring device (2.13.2.) (Page 240)
Related
Flowrate decimal (2.13.4.6.) (Page 245)