Siemens HydroRanger 200 HMI - Page 365

Programming chart
G.1 Programming chart
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
363
Parameter
Altered values for indices/point numbers
1
2
3
Independent mA Setpoints
4 mA Setpoint (2.5.5.) (Page 182)
20 mA Setpoint (2.5.6.) (Page 182)
mA Output Limits
Minimum mA Limit (2.5.7.)
(Page 182)
Maximum mA Limit (2.5.8.)
(Page 182)
mA Output Trim
4 mA Output Trim (2.5.11.)
(Page 183)
20 mA Output Trim (2.5.12.)
(Page 183)
Fail-safe Mode (2.4.4.) (Page 178)
mA Input
mA Input Range (2.6.1.) (Page 184)
0/4 mA Level Value (2.6.2.)
(Page 184)
20 mA Level Value (2.6.3.)
(Page 184)
mA Damp Filter (2.6.4.) (Page 185)
Scaled mA Input Value (2.6.5.)
(Page 185)
Raw mA Input Value (2.6.6.)
(Page 185)
Discrete Input Functions
Discrete Input 1 (2.9.2.1.)
(Page 209)
Discrete Input 2 (2.9.2.2.)
(Page 209)
Discrete Input 1 Scaled State
(2.9.2.3.) (Page 210)
Discrete Input 2 Scaled State
(3.3.1.4.) (Page 267)
Record Temperatures
Transducer Temperature Maximum
(3.2.10.2.) (Page 261)
Transducer Temperature Minimum
(3.2.10.3.) (Page 261)
TS-3 Temperature Maximum
(3.2.10.3.) (Page 261)
TS-3 Temperature Minimum
(3.2.10.5.) (Page 262)