Siemens HydroRanger 200 HMI - Page 364

Programming chart
G.1 Programming chart
HydroRanger 200 HMI
362 Operating Instructions, 06/2018, A5E36281317-AC
Parameter
Altered values for indices/point numbers
1
2
3
Relays
Level Source (2.8.1.2.) (Page 194)
Preset Applications (2.8.1.3.)
(Page 194)
Relay Function (2.8.1.4.) (Page 195)
ON Setpoint (2.8.1.5.) (Page 197)
OFF Setpoint (2.8.1.6.) (Page 197)
Relay Interval Setpoint (2.8.2.4.)
(Page 202)
Relay Dead Band (2.8.2.5.)
(Page 203)
Relay Logic (2.8.1.11.) (Page 199)
Relay Logic Test (3.2.7.) (Page 255)
Pump Setpoint Modifiers
Pump by Rate (2.8.1.8.) (Page 198)
Service Ratio (2.8.1.12.) (Page 200)
Independent Relay Fail-safe
Relay Fail-safe (2.8.2.3.) (Page 201)
Advanced Pump Control Modifiers
Run-ON Interval (2.8.2.7.1)
(Page 205)
Run-ON Duration (2.8.2.7.3.)
(Page 206)
Delay Between Starts (2.8.2.8.1.)
(Page 207)
Power Resumption Delay (2.8.2.8.2.)
(Page 207)
Level Setpoint Variation (2.8.2.6.2.)
(Page 204)
Pump Group (2.8.2.2.) (Page 201)
Flush Systems
Flush Pump (2.10.3.2.) (Page 216)
Flush Cycles (2.10.3.3.) (Page 217)
Flush Interval (2.10.3.4.) (Page 217)
Flush Duration (2.10.3.5.)
(Page 217)
mA Output
mA Output Range (2.5.2.)
(Page 180)
Current Output Function (2.5.3.)
(Page 181)
mA Output Allocation (2.5.4.)
(Page 181)