Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
197
Sets the process point at which the relay changes from its Normal state.
Relay
Preset: ----
• Relay function (2.8.1.4.) (Page 195)
• OFF setpoint (2.8.1.6.) (Page 197)
• Preset applications (2.8.1.3.) (Page 194)
For most applications, the relay is tripped at this point. For In-bounds and Out-of-bounds
alarms, it is the high point in the specified range. This parameter is set according to Span
(2.2.2.) (Page 169) even when another reading, such as volume, is shown on the local
display.
Sets the process point at which the relay returns to its Normal state.
Values
Related
• Relay function (2.8.1.4.) (Page 195)
• ON setpoint (2.8.1.5.) (Page 197)
• Preset applications (2.8.1.3.) (Page 194)
For most applications, the relay is tripped at this point. For In-bounds and Out-of-bounds
alarms, it is the high point in the specified range. This parameter is set according to Span
(2.2.2.) (Page 169) even when another reading, such as volume, is shown on the local
display.
Level selector (2.8.1.7.)
Sets the Level Point index for all parameters applicable to this sub-menu.
To Next Page
Loading...
