Siemens HydroRanger 200 HMI - Page 375

LCD menu structure
H.1 LCD Menu Structure
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
373
1.2. PUMP CONTROL (Page 83)
START OF QS PUMP CONTROL WIZARD
(Page 83)
RELAY SELECTOR
(Page 84)
RELAY FUNCTION
(Page 84)
LEVEL SOURCE
(Page 84)
SERVICE RATIO****
(Page 84)
PUMP HOURS****
(Page 85)
ON SETPOINT
(Page 85)
OFF SET
POINT (Page 85)
CONFIGURE ANOTHER RELAY
(Page 86)
END OF QS PUMP CONTROL WIZARD (Page 86)
2. SETUP (Page 162)
2.1. SENSOR (Page 162)
2.1.1. UNITS
(Page 162)
2.1.2. LEVEL SELECTOR
(Page 162)
2.1.3. SENSOR MODE
(Page 163)
2.1.4. TRANSDUCER SELECTOR
(Page 164)
2.1.5. TRANSDUCER
(Page 164)
2.1.6. MATERIAL
(Page 165)
2.1.7
. SHORT SHOT FREQUENCY (Page 165)
2.1.8. LONG SHOT FREQUENCY
(Page 165)
2.1.9. SHORT SHOT DURATION
(Page 166)
2.1.10. LONG SHOT DURATION
(Page 166)
2.1.11. NUMBER OF SHORT SHOTS
(Page 166)
2.1.12. NUMBER OF LONG SHOTS
(Page 167)
2.1.13. SHOT SYNCHRO
(Page 167)
2.1.14. SCAN DELAY
(Page 167)
2.1.15. SCAN TIME
(Page 168)
2.1.16. SHOT DELAY
(Page 168)
2.1.17. SHOT/PULSE MODE (Page 168)
2.2. CALIBRATION (Page 169)
2.2.1. LEVEL SELECTOR
(Page 169)
2.2.2. SPAN
(Page 169)
2.2.3. TRANSDUCER SELECTOR
(Page 169)
2.2.4. EMPTY
(Page 170)
2.2.5.
SENSOR OFFSET (Page 171)
2.2.6. BLANKING
(Page 171)
2.2.7. RANGE EXTENSION (Page 172)