Electrical connection
5.6 Additional system components
SINAMICS DCP
102 Operating Instructions, 09/2019, A5E34382853K
5.6.4.8 Protective conductor connection and shield support
It is always advisable to shield the digital input/output wiring.
The following diagrams show typical Weidmüller shield connection terminals for the shield
supports.
Shield connection terminal, Weidmüller company, type: KLBUE CO1, Article number:
Protective conductor connection M4 / 1.8 Nm
Figure 5-32 Shield supports
Damage or faulty operation due to incorrect shielding or inadmissible cable lengths
If the correct shielding procedures and the permissible cable lengths are not observed, the
machine can be damaged or may malfunction.
• Only use shielded cables.
• Do not exceed the cable lengths stated in the technical data.
To Next Page
Loading...
