Siemens sinamics dcp - 7.16.3.4 Parameters and function diagrams for faults and alarms

Operation
7.16 Diagnostics
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
371
Note
An ex
ternal fault or alarm is triggered by a 1/0 signal.
An external fault and alarm do not usually mean that an internal message has been
generated. The cause of an external fault and alarm should therefore be corrected outside
the SINAMICS DCP.
7.16.3.4 Parameters and function diagrams for faults and alarms
Function diagrams (see SINAMICS DCP List Manual)
● 8060 Faults and alarms – fault buffer
● 8065 Faults and alarms – alarm buffer
● 8070 Faults and alarms – fault/alarm trigger word r2129
● 8075 Faults and alarms – fault/alarm configuration
Overview of important parameters (see the SINAMICS DCP List Manual)
● r0944 Counter for fault buffer changes
...
● p0952 Fault incident counter
● p2100[0...19] Fault code for fault reaction selection
...
● r2139 Status word for faults
● r3120[0...63] Component number fault
● r3121[0...63] Component number alarm
● r3122[0...63] Diagnostics attribute fault
● r3123[0...63] Diagnostics attribute alarm