Siemens sinamics dcp - 5.6.3.5 Meaning of the LEDs on the Terminal Module TM15

Electrical connection
5.6 Additional system components
SINAMICS DCP
80 Operating Instructions, 09/2019, A5E34382853K
5.6.3.5 Meaning of the LEDs on the Terminal Module TM15
Table 5- 18 Meanings of the LEDs on the Terminal Module TM15
LED
Color
Status
Description, cause
Remedy
READY - Off The electronics power supply is missing or outside the per-
missible tolerance range.
–
Green Continuous
light
The component is ready for operation. Cyclic DRIVE-CLiQ
communication is taking place.
–
Orange Continuous
light
DRIVE-CLiQ communication is being established. –
Red Continuous
light
This component has at least one fault.
Note:
The LED is activated irrespective of whether the correspond-
ing messages have been reconfigured.
Remove and
acknowledge the
fault.
Green/
red
Flashing
light 0.5 Hz
Firmware is being downloaded. –
Flashing
light 2 Hz
Firmware download has been completed. The system waits
for POWER ON.
Carry out a POWER
ON.
Green/
orange
or
Red/
orange
Flashing
light
Component recognition via LED is activated
1)
.
Note:
Both options depend on the LED status when component
recognition is activated.
–
1)
See SINAMICS DCP List Manual for the parameters to activate the recognition of components via LED
Cause and rectification of faults
The following documents contain information about the cause of faults and how they can be
rectified:
SINAMICS DCP List Manual