SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
3
Device firmware release
As these Operating Instructions went to print, SINAMICS DCP devices were being supplied
from the factory with the firmware release specified on the inside front page. However, these
Operating Instructions can, in principle, also apply to other firmware releases.
●
Older firmware releases
It is possible that not all of the functions described here are actually available.
●
Newer firmware releases
It is possible that the SINAMICS DCP may feature additional functions that are not
described in these Operating Instructions. Do not change any parameters that you cannot
find in the List Manual from their factory setting, and do not give parameters any values
that are not specified in the List Manual.
The firmware release is displayed indicated in r50060[6].
Example:
01010203 displayed on the BOP20 means 01.01.02.03 → Version 1.1, Service Pack 2,
Hotfix 3
Downloading the latest firmware release
(https://support.industry.siemens.com/cs/ww/en/view/109474935)
SINAMICS DCP documentation available
SINAMICS DCP Operating Instructions
Contains all information on
ordering, installation, connecting, commissioning, maintaining, description of functions,
and service
parameter list, function diagrams, list of faults and alarms
SINAMICS Free Function Blocks, Commissioning Manual
Contains a general description, the list of parameters, the function diagrams as well as
the list of faults and alarms.
Manuals in the Internet
The manuals are also available in the Internet:
Manuals (https://support.industry.siemens.com/cs/ww/en/ps/13302)
The list of general conditions available there include current supplements to the manuals.
The notes included in the general condition lists have a higher priority than the statements
made in the manuals.
To Next Page
Loading...
