Commissioning
6.3 Commissioning using the STARTER commissioning tool
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
143
6.3.2.5 Starting the drive project
You have generated a project and saved it to your hard disk. The next step is to transfer your
project configuration data to the drive unit.
Transferring a STARTER project to the drive unit
The following steps are required to transfer the STARTER project created offline to the drive
unit:
●
Step 1
Select the menu command
Project > Connect to target system
Selection in the toolbar:
To Next Page
Loading...
