Siemens sinamics dcp - 7.8.5 Messages and parameters

Operation
7.8 Communication via EtherNet/IP (EIP)
SINAMICS DCP
310 Operating Instructions, 09/2019, A5E34382853K
7.8.5 Messages and parameters
Faults and alarms (see SINAMICS DCP List Manual)
•
F08501 (N,A)
PN/COMM BOARD: Setpoint timeout
•
F01910 (N,A)
Fieldbus: Setpoint timeout
•
A08526 (F)
PN/
COMM BOARD: No cyclic connection
•
A01980 (F)
PN: Cyclic connection interrupted
•
A50011 (F)
EtherNetIP/COMM BOARD: Configuration error
Overview of important parameters (see the SINAMICS DCP List Manual)
•
p0922
IF1 PROFIdrive PZD telegram selection
•
p0978[0...n]
List of drive objects
•
p0999[0...99]
List of modified parameters 10
•
p2030
Fieldbus interface protocol selection
•
p8835
CBE20 firmware selection
•
p8940[0...239]
CBE2x Name of Station
•
p8941[0...3]
CBE2x IP address
•
p8942[0...3]
CBE2x Default Gateway
•
p8943[0...3]
CBE2x Subnet Ma
sk
•
p8944
CBE2x DHCP mode
•
p8945
CBE2x interfaces configuration
•
r8950[0...239]
CBE2x Name of Station actual
•
r8951[0...3]
CBE2x IP address actual
•
r8952[0...3]
CBE2x Default Gateway actual
•
r8953[0...3]
CBE2x Subnet Mask actual
•
r8954
CBE2x DHCP Mode actu
al
•
r8955[0...5]
CBE2x MAC address
•
r8956[0...1]
CBE2x cyclic connection state
•
r8957[0...5]
CBE2x cyclic connection diagnostics