Siemens sinamics dcp - 5.6.1.5 Assembling the 30 kW device

Electrical connection
5.6 Additional system components
SINAMICS DCP
66 Operating Instructions, 09/2019, A5E34382853K
5.6.1.5 Assembling the 30 kW device
Figure 5-15 Assembling the CBE20
1. Loosen the screw ①
2. Detach and remove the front plate
②
3. Loosen the screws
③
4. Pull out the electronics rack unit
④
5. Push the CBE20 into the option module interface (see the following diagram)
6. Reinsert the electronics unit
④
7. Tighten the screws
③ again
8. Attach the front plate
② again
9. Tighten the screw
③ again