Siemens sinamics dcp - 8.1.1.3 Update the STARTER project; 8.1.1.4 Load to the target system - copy RAM to ROM

Servicing
8.1 Upgrading firmware releases
SINAMICS DCP
418 Operating Instructions, 09/2019, A5E34382853K
4. Carry out a POWER ON. The new firmware is now active.
If a memory card is already in the SINAMICS DCP, the mechanism described in Chapter
"Memory card functions (Page 158)", Section "Copying parameter data sets from non-
volatile memory to the memory card" takes effect.
5. When running-up for the first time, connected TM modules carry out a firmware update. A
POWER OFF / POWER ON of these components is required after the firmware update.
The memory card no longer needs to be inserted for this step.
Note
Electronic power supply must not be interrupted during the update, otherwise the update wi
ll
need to be restarted.
Note
To safely remove the memory card, see Chapter "
Memory card functions (Page 158)".
8.1.1.3 Update the STARTER project
Install the SSP that matches the new SW version (e.g. SSP SINAMICS DCP V1.3).
SSPs for different versions of the same SINAMICS DCP can be simultaneously installed in
STARTER.
Open the existing STARTER project (that refers to an old device version). Right-click the
device in the project navigator and select "Target device" → "Device version…". Select the
new device version and confirm with "Change version". The project is converted to the new
device version.
Note
STARTER does not support a "downgrade" of the firmware version (e.g. V1.3 to V1.2).
8.1.1.4 Load to the target system - copy RAM to ROM
Load the project into the SINAMICS DCP (load to the target system) and permanently save
the parameter assignment (carry out a "Copy RAM to ROM").