Siemens sinamics dcp - 5.6.4 Terminal Module TM31; 5.6.4.1 Description; 5.6.4.2 Safety instructions

Electrical connection
5.6 Additional system components
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
87
5.6.4 Terminal Module TM31
5.6.4.1 Description
The TM31 is a terminal expansion module for snapping onto a mounting rail according to EN
60715. The TM31 Terminal Module can be used to increase the number of available digital
and analog inputs and outputs within a drive system.
The TM31 contains the following interfaces:
Table 5- 20 Interface overview of the TM31
Type
Quantity
DRIVE-CLiQ interfaces
2
Digital inputs 8
Bidirectional digital inputs/outputs
4
Analog inputs 2
Analog outputs
2
Relay outputs
2
Temperature sensor input
1
Supported types
SINAMICS DCP only supports one version of the Terminal Module TM31:
Table 5- 21 TM31 types
Article number TM31
Use with SINAMICS DCP
6SL3055-0AA00-3AA0
Not possible
6SL3055-0AA00-3AA1
Possible
5.6.4.2 Safety instructions
WARNING
Non-observance of the safety instructions
If the safety instructions in Chapter 1 are not observed, accidents can occur involving
severe injuries or death.
• Make sure that the safety instructions are observed.